ACRYLIC TOUCH UP PAINT

RAL TOUCH UP PAINT

An Acrylic Touch Up Paint formulated with acrylic resins for fast drying with an excellent surface finish. Can be used on a variety of surfaces, particularly metals, in diverse areas of activity such as touching-up paintwork on agricultural machinery or construction plant, fencing, industrial maintenance and paint repairs, and to identify pipework (RAL safety and warning references).

PROPERTIES OF ACRYLIC TOUCH UP PAINT

  • Rapid drying
  • Easy to apply, both a first coat additional coats as required
  • Particularly good covering power
  • A very flexible paint film with a superb gloss finish
  • Long-lasting even outdoors
  • Good adhesion to a range of different surfaces
  • Touch dry (ASTMD-1640 ISO 1517): 10 to 15 minutes
  • Completely dry (ASTMD-1640 ISO 1517): 12 hours
  • Temperature resistance: 120°C
  • Leave to dry for 15 minutes between coats
  • Dry film thickness: 15μ/coat

FOUR PICTOGRAMS

produit toxique goodproduit inflammablepicto dangereux pour la santeproduit sous haute pressionproduit dangereux pour lenvironnement

 

CARACTERISTICS OF THE ACRYLIC TOUCH UP PAINT

ral 1003 ral 1023 ral 2010 ral 3020 ral 5002

RAL 1003 - SIGNAL YELLOW GLOSS
ref : 461003BUSCAN

RAL 1023 - TRAFFIC YELLOW GLOSS
ref : 461023BUSCAN

RAL 2010 – SIGNAL ORANGE GLOSS
Ref : 462010BUSCAN

RAL 3020 - TRAFFIC RED GLOSS
Ref : 463020BUSCAN

RAL 5002 - ULTRAMARINE BLUE GLOSS
Ref : 465002BUSCAN
ral 6005

ral 7001

ral 9005 gloss

ral 9005 mat

ral 9016
RAL 6005 - MOSS GREEN GLOSS
Ref : 466005BUSCAN		 RAL 7001 - SILVER GREY GLOSS
Ref : 467001BUSCAN		 RAL 9005 - JET BLACK GLOSS
Ref : 469005BUSCAN		 RAL 9005 - JET BLACK MAT
Ref : 469005MUSCAN		 RAL 9016 - TRAFFIC WHITE GLOSS
Ref : 469016BUSCAN

Composition

Binder: acrylic

Solvent: blend of solvents, free from lead and heavy metals

Propellant: dimethyl ether

APPLICATION METHOD OF THE ACRYLIC TOUCH UP PAINT

  • Thoroughly shake the aerosol for at least 2 minutes before use to ensure the pigments are correctly mixed.
  • The surface must be clean, dry and free from grease. Degrease the surface to be treated, remove rust and dust.
  • To improve adhesion, it is recommended to apply an undercoat prior to use, depending on the condition of the surface to be treated.
  • Spray at a distance of 25 cm from the surface.
  • Best results are obtained by applying several thin coats in different directions rather than a single thick coat.
  • Coverage approximately 2m² per can according to the application conditions and the state of the surface to be treated.
  • If appropriate, carry out a test on an unobtrusive area beforehand to verify the compatibility of the paint with the surface.

HEALTH AND SAFETY

GHS labelling with three pictograms.